pias® wing-type drilling screw, countersunk milling head with AW drive
Wing-pias steel flake zinc cntrsnk. milling hd. AW
SCR-DBIT-WNG-CS-CUTHD-AW40-(RUS)-8X65
ZEBRA PIAS
Register now and access more than 125,000 products
Steel, Ruspert®-coated (grey)
Corrosion protection
Approx. 500 hrs. no base metal corrosion in accordance with DIN EN ISO 9227 — NSS
AW drive system:
- Enhanced torque transmission
- Longer life
- Optimum centring
- Better mounting output thanks to fatigue-free screwing in; the required contact pressure for transmission of the torques is considerably lower
- Largest possible contact surface of bit in screw drive
- Even force distribution prevents damage to the surface-protection coating and therefore ensures better resistance to corrosion
- Wing-pias screws must be appropriately tested for usability for each application case. Only install using application tools with a depth stop and claw coupling.
- The maximum attachment length is calculated as follows: Wood thickness and surface thickness lU = max. attachment length
- Drilling screws must be processed with a suitable drill driver (e.g. cordless drill driver with depth stop)
- The use of impact screwdrivers is not permitted
- Drilling screws must be attached perpendicular to the surface of the component
Drilling screws may only be used where dampness is not to be expected. For connection elements with a construction permit, the permit, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
CAD data (available after login)
For use with hard and soft woods
- Force feeding of the screw is prevented by the wings drilling out the wood
- The core hole is drilled into the substructure. The wings break off upon contact with the metal
- The first few turns of the screw cut the thread, the remainder of the screw then screws into the thread
 | |
Nominal diameter (d) | 8 mm |
Length (l) | 65 mm |
Head diameter (dk) | 15 mm |
Head height (k1) | 5.4 mm |
Drill tip length (lp) | 18 mm |
Other standard | Company standard |
Material | Steel |
Surface | Flake zinc grey |
Head type | Countersunk milling head |
Internal drive | AW40 |
Thread type | Metric thread |
Min. recommended substructure thickness | 3 mm |
Max. material thickness to be drilled through (metal) (lU) | 12 mm |
Max. attachment thickness (lB) | 33 mm |
Min./max. recommended installation speed (idling) | 600-1200 rpm |
RoHS-compliant | Yes |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Ear defenders
Round head screw with square neck and nut DIN 603 with nut, steel, strength class 4.8, zinc-plated, blue passivated
Interchangeable cylinder for locks for glass sliding doors with aluminium rail
Countersunk head screw with recessed head, H DIN 965, steel 4.8, zinc-plated, blue passivated (A2K)
Fleece jacket Job+
Jigsaw blade, wood, three stars multiblade
Centre punch setting jig set For DWD-XP, H95 decor height
Hexagon head bolt DIN EN 14399-4, steel 10.9, hot-dip galvanised (hdg), for high-strength structural bolting assembly
DAILY RACE O2 occupational shoe
Special wrench For oil filling and drain plugs