pias wing-tip self-drilling screw, flat countersunk milling head with AW recess
SCR-DBIT-WNG-PLTCS-CUT-AW30-RUS-6,3X55
Art.-no. 021906355
EAN 4038898045922
Register now and access more than 125,000 products
- Cr(6)-free corrosion protection, approx. 500 h with no base metal corrosion (salt spray test as per DIN EN ISO 9227-NSS)
- AW recess system for better torque transmission, a longer service life and optimal centring
- Wing-tip pias screws must be appropriately tested for usability for each application. Only install using application tools with a depth stop and claw coupling.
- The maximum fixture length is calculated as follows: Wood thickness and substructure thickness lU = max. fixture thickness lB
- Self-drilling screws must be installed with a suitable drill/driver (e.g. cordless drill/driver with depth stop)
- The use of impact drivers is not permitted
- Self-drilling screws must be screwed in perpendicular to the surface of the component
Zinc plated self-drilling screws must only be used in locations where permanently damp conditions are not expected - condensation is not considered a permanently damp condition (corrosivity category ≤ C2 in accordance with DIN EN ISO 12944-2). For fasteners with technical approval, the approval, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
For use with hard and soft woods
- Force feeding of the screw is prevented by the wings drilling out the wood
- The core hole is drilled into the substructure. The wings break off upon contact with the metal
- The first few turns of the screw cut the thread, the remainder of the screw then screws into the thread
 | |
Nominal diameter (d) | 6.3 mm |
Length (l) | 55 mm |
Head diameter (dk) | 20 mm |
Drill tip length (lp) | 13 mm |
Other standard | Company standard |
Material | Steel |
Surface | Flake zinc grey |
Head type | Disc countersunk head with milling ribs |
Internal drive | AW30 |
Thread type | Self-tapping screw thread |
Min. recommended substructure thickness | 2 mm |
Max. material thickness to be drilled through (metal) (lU) | 6 mm |
Max. attachment thickness (lB) | 33 mm |
Min./max. recommended installation speed (idling) | 800-1200 rpm |
RoHS-compliant | Yes |
Last viewed
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain
ASSY 4 CSMP universal screw Steel zinc plated partial thread countersunk milling pocket head
TIPP-Express pipe clamp with hinge
MFD-S multi-purpose drill bit, 1/4-inch hexagonal shank
Hexagon bolt with thread up to the head ISO 4017, steel 10.9, plain
Tapered pin, unhardened DIN 1, A1 stainless steel, plain
Oil filter wrench
Multi-socket wrench, 1/2 inch 23 pieces
Long handle For panel beating hammers
Wood screw Hexagon head DIN 571, A4 stainless steel