pias® drilling screw, flat head with AW drive
pias steel zinc plated pan head AW
SCR-DBIT-PANHD-AW25-(A2K)-4,8X110
Art.-no. 020648 110
EAN 4045989403431
Register now and access more than 125,000 products
Assembly time reduced by at least 50 % using the drill tip
- Drilling without centre-punching
- Thread forming
- Fastening
all in one operation
Additional optimal torque transmission by the AW drive
Suitable for component combinations tI/tII in accordance with approval ETA-10/0184
- Steel/steel for dia. 4.2 mm, 4.8 mm and 5.5 mm
- Contact pressure during use approx. 100 N, screw in with depth stop if necessary.
- Drilling screws must be processed with a suitable drill driver (e.g. cordless drill driver with depth stop)
- The use of impact screwdrivers is not permitted
- Drilling screws must be attached perpendicular to the surface of the component
Galvanized drilling screws may only be used where dampness is not to be expected. For fasteners with a construction permit, the permit, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
RoHS-compliant | Yes |
Nominal diameter (d1) | 4.8 mm |
Length (l1) | 110 mm |
Internal drive | AW25 |
Last viewed
Spyhole, type B With crystalline lens and 200° viewing angle
Protex finish
Metric combination wrench 12 pieces with POWERDRIV® drive
Hexagon bolt with thread up to the head ISO 4017, steel 8.8, plain
Thin-walled heat-shrink hose shrink rate 2:1 without internal adhesive
Note block with neon stripes
Insulation holder W-DH
Lashing plate, aluminium
System connector SV 20 E
Hose set for TOP Gun cleaning and washing appliances