Waterproof elastic coating suitable for foot traffic RECULASTIC

Apply on consolidated and restored substrates that are dry, clean and free from grease, dust, dirt and vegetation that can prevent good adhesion. Do not apply on water repellent treatment.

On hard, slightly absorbent mineral-based substrates with joints, apply RECUPRIMER first, avoiding accumulations but saturating the surface.

Dilute to a maximum of 10 % with water on porous substrates.

On small surfaces and for touch-ups, apply with a long-haired brush. With a wool roller, apply in crossed coats without overspreading. Use an airless gun when applying to large surfaces to avoid the risk of contamination. Ensure that the coating is regular and adequate to the relief of the substrate.

Use 0.018 to 0.021 inch nozzles; dilute with water approx. 5 %.

On horizontal surfaces with a risk of water pooling, or to improve resistance to sun exposure, apply a layer of Reculastic on the Recuflexim system.

Avoid direct application in the sun or on very hot or cold surfaces at extreme temperatures or when rain is forecast 3 to 4 hours after application. Do not apply when there is a risk of condensation during drying.

For roofs subject to significant expansion, use a 60 to 80 g/m² fibreglass mesh.

Reinforce cracks, edges and critical points with partial or total reinforcement.

On vertical surfaces and for the anti-carbonation process, apply 2 or 3 coats depending on the roughness and porosity of the substrate.

Store in the original sealed containers at temperatures between 5°C and 40°C.