VAKU MULTI filler
Filler, VAKU MULTI
FILR-(VAKU-MULTI)-2,5KG
Register now and access more than 125,000 products
- Can be used as coarse or fine filler
- Outstanding adhesion on a wide variety of substrates, in particular on galvanic sheet steel, hot-dip galvanised bodywork panels, sheet steel, aluminium, wood, polyester-based GFRP parts
- Good application even on vertical surfaces
- Slight post-hardening
- Easy to sand
The ambient and material temperature for application should be between +18°C and +25°C. Do not apply below +5°C.
Vehicle repairs and industry.
Carefully clean the substrate of rust, dirt, grease and old, loose paint remnants and then sand. Mix the required amount of filler thoroughly with approx. 2% of hardener paste and then apply within 4 to 6 minutes. Reason for reaction: Wash primers and other acid-hardening surfaces are not suitable substrates.
An excessive amount of hardener paste reduces the pot life but does not accelerate hardening; under unfavourable conditions, this can even cause adhesion problems and/or discolouration on subsequently applied paintwork.
Last viewed
Twist drill bit HSCO DIN 338 type RN
Twist drill bit HSS DIN 338 type RN 118°
1/4 inch socket wrench insert, metric short
3/8 inch socket wrench insert metric, hexagon, short
Circlip pliers, shape A for shaft circlips
Random orbital disc-type sander ETS 150-E twin
1/2" socket wrench insert For TX screws, short
1-ear clamp with insert ring
Flat connector contact Maxi Power Timer (MPT) 9.5
Aluminium telescopic ladder with folding section