Universal fluxing agent no. 50 FM for brazing metal
Universal fluxing agent no. 50 FM f. brazing metal
BRAZFLX-NO50FM-UNI-100G
Register now and access more than 125,000 products
- Flux for brazing copper, brass and red bronze gunmetal
- DIN 29454
- White paste
The residues of the fluxing agent are corrosive and must therefore be removed.
This product is subject to the provisions of the German Chemicals Prohibition Ordinance. Detailed information on the hazards arising from this product, the precautionary steps to be taken during proper use, dealing with spillages or other exposure and ensuring correct disposal can be found in the safety data sheet.
Datasheets(X)
Fluxing agent for hard soldering of copper, brass and gunmetal alloys except for light metals with an operating temperature range from 500°C to 800°C
Mix paste well before using. Apply fluxing agent to the cleaned work piece by brushing or immersion. Flux agent should also be applied to the area around the soldering point.
Weight of content | 100 g |
Colour | White |
Smell/fragrance | Odourless |
Chemical basis | Potassium tetrafluoroborate |
DIN | 29454 |
Shelf life from production | 24 Month |
pH value | 11 |
Density | 1.35 g/cm³ |
Last viewed
Twist drill bit HSS DIN 1897 type RN
Screw-in fitting for pneumatic air
Flat square For FB windowsill duct
Closure For cable tie gun
Single guide rail for Redoslide
Sliding door fitting guide roller SB 20 E
Blade receptacle Uninsulated
Hexagonal nut, low profile DIN 439, steel 04/05, zinc-plated, blue passivated (A2K)
Brake caliper brush
Flat blade fuse MINI-FLP Silver