Thermal impact anchor TSD-V KN
Thermodynamic impact anchor TSD-V KN
DWL-(TSD-V KN)-PLA-NL-PLA-D60MM-8X240
Register now and access more than 125,000 products
- Push-through installation
- Patented hinge joint for installation flush with surface
- Pre-assembled — easier installation
- Head surface allows mortar to grip and can be used as a plaster base
- 3-part expansion area for extra safety even in difficult surfaces
- Plastic nail for maximum protection against heat loss (chi value = 0.000 W/K)
Indicated insulation thickness includes a tolerance of 10 mm (e.g. for insulation adhesive). An existing layer of plaster may result in a reduced maximum insulation thickness in old buildings. The specific construction conditions should therefore always be taken into consideration.
Disc not recessed
Washer INCH
Insulation
Create the drill hole
Clean the drill hole
Insert the anchor flush
Hammer in expansion nail
Countersink anchor flush in the insulation by hammering
Datasheets(X)
Multiple attachment:
Attachment of bonded external composite thermal insulation systems
- In solid, perforated and hollow brick.
- Condition use in concrete
The respective WDVS approval must be considered in all cases
The anchor can also be used for attaching insulating material in natural stone with dense microstructure and aerated concrete (without approval)
To attach soft insulating materials, the anchor can be combined with insulating plate W-DD-B
Last viewed
Marking/expander tool with hand guard
Centre drill bit
Trousers, classic winter
Club hammer
Hammer drill bit Plus Duo-S Vario
Secateurs
Flat paintbrush For solvent-based lacquer and paint systems
Plug-in nipple Series 2000
Sheet metal nut, open screw-in area
Metric combination wrench with POWERDRIV®