Temporary guard rail bracket WA-10
Bracket for temporary guard rail WA-10
BRKT-RL-(WA-10)-H1300MM
Art.-no. 0899964730
EAN 4050641335203
Register now and access more than 125,000 products
- Temporary edge protection system, class A, in accordance with UNI EN 13374:2019
- The edge protection system enables safe work on flat or inclined surfaces made of reinforced concrete (maximum incline below 10°) on buildings or other structures. It is capable of supporting a person who leans on the protection while walking and it stops the person from falling in the direction of the protection itself
- Bracket consisting of two parts, one inside the other, which can be slid using a threaded rod
- Clamp consisting of a fork made from folded sheet metal and a plate, one inside the other, which can be slid using a threaded bar
- Useful height of the bracket measured perpendicular to the work surface: 1 m
- Made of S 235 JR G2 steel, zinc plated
Certifications:
Calculation report: ref. RDC-PT-W-1 dated 01/07/19
Conformity assessment: ref. 0899964730(WA-10) dated 01/07/2019
Before installing the temporary guard rail, ensure that the structure to which it will be fitted is capable of absorbing the loads transferred by the bracket to the anchor point (see point 5 on page 4 of the instruction booklet)
Opening the clamp fully makes the two parts of the bracket come apart. Take care in order to avoid accidents during installation. (Risk of one of the two parts of the bracket falling from a height).
To prevent the bracket from coming away from the anchor point, make a hole with a diameter of 14 mm and a minimum depth of 60 mm on the inner bend of the upper fork and dry-fit a steel rod with diameter of 12 mm x 100 mm (see fig. 1 on the previous page). Cover the protruding part of the rod with a protective cap
Incorrect use of the temporary guard rail could cause a fall or accident. Therefore, please read the instruction booklet carefully before using the equipment for the first time
Datasheets(X)
Conditions of use and limits
- Maximum useful height from the ground: 40 m
- Wind speed not exceeding 30 m/s
- Working surface gradient less than 10°
- The guard rail's inclination should not exceed a 15 degree deviation from the vertical
- Maximum distance between two brackets: 1,600 mm
- Insert spruce wood or other planks (minimum class C16 - UNI EN 338) into the corresponding brackets
- Size of the planks for the handrail, mid-rails and skirting board: 150 x 25 or 150 x 30 mm
 | |
Width | 195 mm |
Height | 1000 mm |
Min. external clamping width | 50 mm |
Max. external clamping width | 800 mm |
Effective height | 1 m |
Max. tilt angle | 10 Degree |
Max. worktop height | 40 m |
Suitable for max. wind speeds | 30 m/s |
EN standard | 13374 |
Material | Steel |
Surface | Zinc plated |
Product weight (per item) | 5600.000 g |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Hexagon nut, low profile with fine thread DIN 439, steel 4, plain
Wall spacer for all leaning ladders for work on overhanging roofs
Anti-vibration handle
Dowel pins
Hexagonal bolt with thread up to head ISO 4017, hot-dip galvanised 8.8U steel (TZN)
1/4 inch socket wrench insert, metric short
Storage box (empty)
Cup-shaped mask CM 3000, carbon V FFP2 NR D
Bond + Seal structural adhesive
1/4 inch socket wrench insert, metric short