Stripping gel for stainless steel welding
Stainless steel cleaning paste
RUSTFLMREM-SST-PASTE-1KG
Register now and access more than 125,000 products
- 1 kg pack
- Easy to apply
- Short activation period
- Does not drip
- Excellent adhesion
- Contains fewer nitric gases
Always wear protective clothing. Highly toxic product.
Stainless steel sawmills
Shake before use. Apply after the weld has cooled to room temperature. Avoid temperatures below 5°C. Clean the welding seam with a stainless steel brush and then apply a relatively thick layer of paste. For AISI 304 and 316 steels, leave the paste to work for 60 minutes. For steels with higher alloys or molybdenum alloys, the action period may need to be extended, even up to 24 hours in some cases. Carefully clean with a damp stainless steel brush and then rinse thoroughly with water. The seam will then be clean and shiny with better anti-corrosion protection.
Weight of content | 1 kg |
Färg | Colourless |
Smell/fragrance | Pungent |
Density | 1.25 g/cm³ |
Chemical basis | Nitric acid |
pH value | 2 |
Last viewed
Fine-grain pen
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
1/4" multi-socket wrench insert bi-hex, multi profile
Hexagonal bolt, fully threaded, SB fittings, DIN EN 15048-1
Hand cleaner in tub
Hand tap, second tap HSS DIN 352
Butt connector, heat shrink, solder
Bermuda shorts SMART
1/4 inch cardan joint
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
