Single-sided tooth plate connector type C2

Name: Single-sided tooth plate connector type C2
Brand: Würth
SKU: 045101175

Wood connector/ press-in anchor type C2
DWL-EN912-C1-ONESIDED-(SZN)-D75/16MM

Art.-no. 045101175

EAN 4011231385886

All versions

Similar products

Prices for customers after login

Single-sided tooth plate connector type C2

Art.-no. 045101175

Prices for customers after login

Quantity

x 100 pcs

Exclusively for trade customers

Login/Register
Call customer service: +34928189825

Single-sided tooth plate connectors (type C2) are used for metal-wood or wood-wood connections (softwood) in combination with bolts or wood screws to absorb shear forces. The bolts or screws subject to load absorb the clamping and tensile forces in the bolt axis.

In line with DIN EN 912:2011-09

2 nail holes, d = 3.5 mm

Material: St 1203 or DC 01 + C390 steel in line with DIN EN 10139

Surface: Sendzimir galvanised

Application in utilisation classes 1 and 2

Notice

Transverse load in the compressed surfaces should not be higher than 2.5 N/mm² for solid wood or 3 N/mm² for laminated wood.

Available work documents:

Load tables and detailed processing instructions can be found on the service page www.wuerth.de/holzverbinder.

CE marking in line with EN 912 pending.

Product information

Würth Catalogue

Datasheets(X)

Certificates/ Documents

Application area

Used to manufacture double-shear, shear-loaded metal–wood and wood–wood connections made from softwood, e.g. half-lap joints, frame corners and collar beams.

Instructions

Single-sided tooth plate connectors, type C2, are attached using dowel pins and nuts. Alternatively, ASSY wood screws can be employed. Suitable fasteners: Bolts with washers and ASSY 3.0 Combination screw.

Assembly

1. Bore a hole for the bolt and nut in the timber component. The bore diameter for bolts in wood may only be max. 1 mm larger than the nominal diameter of the bolt. The bolt must rest against the metal tab and against the tooth plate connector.

2. Position the single-sided tooth plate connector in the timber component. The tooth plate connectors can be fixed in place using the nail holes. It is not permitted to drive in the connector by hitting the teeth directly.

3. Drive in the tooth plate connector by tightening the bolt torque or using a hydraulic driving tool. Alternatively, special driving tools can be used.

4. Tighten the bolts if the wood cross-section tapers.

Type	C2
Design	One side
Nominal diameter	75 mm
Diameter of hole	16.4 mm
Thickness	1.25 mm
Height	10.4 mm
Number of external teeth	12 PCS
Nail-hole diameter	3.5 mm
Material designation	HX340LAD
Surface	Hot dip galvanized
Material	Sheet steel
EN standard	912