Setting tool for W-SA TC Timber Connect concrete screw anchors
Screw anchor setting tool, W-SA TC Timber Connect
STGTL-(F.ANC-(W-SA-TC))-D12
Register now and access more than 125,000 products
- The setting tool prescribed for the installation of the W-SA TC in accordance with approval Z-21.1-1917
- With embedment depth mark, so that the screw anchor can be installed correctly depending on the height of the fixture
- Coordinated system of screw drive and bit for an improved fit and optimum load transmission
- TX30 for W-SA TC 7.5 - for tangential impact drivers with 1/4 inch hexagon socket drive
- TX45 for W-SA TC 10 - for tangential impact drivers with 1/2 inch square drive
- TX50 for W-SA TC 12 - for tangential impact drivers with 1/2 inch square drive
Datasheets(X)
The W-SA TC Timber Connect screw anchor must be fitted using the appropriate setting tool and a suitable tangential impact driver. The required length of thread engagement (hnom) in the concrete must be observed. The thickness of the fixture can be selected via the marking on the setting tool. The required length of thread engagement is reached when the marking is flush with the surface of the wooden fixture.
Diameter (Ø) | 12.0 mm |
Tip size | TX50 |
Type description | H 43605-T50 |
Drive type | Internal square |
Drive | 1/2 inch |
Length | 260 mm |
Last viewed
Polo shirt Job+
Concealed slide full-extension slide Dynapro With integrated soft-close system
LED side marker light 24V Universal
Twist drill bit HSS DIN 338 type RN 118°
Hexagonal bolt with shank, SB FITTINGS, DIN EN 15048-1 DIN 7990, steel 4.6, hot-dip galvanised (hdg)
Twist drill bit HSCo DIN 338 type RN oxide
3/8" socket wrench bi-hex, multi profile
Hexagon Socket Head Cap Screw with low Head DIN 7984, A2-070 stainless steel, plain
Feather key, high profile DIN 6885, steel C 45 K, plain, shape A
Stick-on cover cap