Selective cleaner for construction
Façade cleaner SELECTIVE
FCDECLNR-SELECTIVE-WTRBSE-10LTR
Register now and access more than 125,000 products
General purpose on walls, floors, ceilings and general surfaces.
Ideal for preparing surfaces before applying other protective treatments such as impregnations, consolidators, water repellents and anti-graffiti protection.
Remarkable descaling power.
Leaves pores clean, open and ready for further treatments.
Wide spectrum of applications.
For indoor and outdoor use.
Formulated in an aqueous base.
This makes it particularly compatible with moisture and provides good penetration into the surfaces it is applied to.
Sometimes saltpetre may reappear after the first cleaning has dried. This second dry salt bloom will require a cleaning and rinsing again.
These instructions are merely recommendations based on our experience. We recommend performing tests for each new type of application or surface to be treated.
Datasheets(X)
Walls, construction works, restorations and industry in general. Especially on horizontal and vertical surfaces suffering from the effects of moisture, saltpetre blooms, environmental pollution and their consequences.
Use plastic to protect sensitive surfaces that should not be treated. Apply to the affected surface with a brush or spray. Focus on where reaction triggers and rub with a brush in the affected area. Rinse with water before the product and the dissolved dirt dry. Allow to dry before proceeding with other treatments.
Use undiluted or dissolved in water up to a general rule of a 1:4 ratio in water, depending on the surface. The higher the concentration, the faster the action and the greater the salt dissolution capacity.
Storage
Maximum recommended storage time: four years in its original container, well sealed and sheltered from the elements (under cover at a temperature between 5°C and 25°C).
Last viewed
Polishing pads
3/8-inch socket wrench insert, metric long
Plug-in nipple Series 2000
Clamping pin/clamping sleeve, slotted, heavy-duty design ISO 8752 spring steel plain
Hole puncher assortment 12 pieces with manual hydraulic punch
Rivet nut setting pliers HES 510 OZS
1/2 inch and 1/4 inch socket wrenches Assortment of 56 pieces
Wire stripping pliers, adjustable
Holder For 12 mm, 20 mm and 30 mm countersinks
Cover caps For aluminium airline lashing rails