Sealproof accelerant EVO
Additive for surface coating Sealproof EVO
ADD-SRFCOAT-PU-TRANSP-1KG
Register now and access more than 125,000 products
Accelerates the cure time of the Sealproof EVO.
Drying time approximately 15°C for 4-6 hours.
Eliminates air formation inside the membrane.
Eliminates curing bubbles and other defects in the Sealproof EVO membrane.
Increased product thixotropy.
Allows Sealproof EVO to be applied in thick layers
The entire product must be mixed with Sealproof EVO 25 kg to achieve the desired effects.
These instructions are merely recommendations based on our experience. We recommend performing tests for each new type of application or surface to be treated.
Datasheets(X)
The product is formulated to act in combination with 25 kg of Sealproof EVO, without affecting the properties of the resulting membrane. Add accelerant to the liquid membrane and mix gently with an electric mixer until completely homogenised. Leave to stand for a few minutes before applying. Once an accelerant has been added to the Sealproof EVO, it is recommended that no other diluent be added
Consumption:
The ratio between the Sealproof EVO accelerant and Sealproof EVO 25 kg is 1 litre/25 kg.
Weight of content | 1.5 kg |
Contents | 1 l |
Colour | Transparent |
Chemical basis | Aromatic amine |
Density | 0.87 g/cm³ |
Shelf life from production | 12 Month |
| Appearance | Concentrated liquid |
| Pot life | 20-30 min. 25°C |
| Storage temp | 5°C to 25°C |
Last viewed
Packfix packing film
Hook and loop fastener support plate For dust-free working and optimum results
Classic Bermuda work shorts
Angle grinder EWS 7-115 BASIC
Storage box (empty)
Allen key set with lock washer
Ratchet for 10 mm bits
Holstein sand shovel without shaft
Precision twist wood drill bit assortment HSCo, 10 pieces
Blind rivet, open, with break mandrel and flat head ISO 15979, dome head, steel/steel