Satin-finish wheel brush for wood crimped, with hole
Stranded wire brush
BRSH-STRAWRE-SATNFINR-(MS)-100X70X19MM
Register now and access more than 125,000 products
- Excellent for surface structuring work on large-scale workpieces
- Increased brushing effect
- Additional holding of the wires through the stranded construction
- For use on angle grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Can be used on all standard brush sanders.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
- Deburring and removal of rust and dirt
- Brushing out the soft annual rings in coniferous wood
- Roughing of the surface of hardwoods
Diameter x width x drill hole (DxBxA) | 100 x 70 x 19 mm |
Design | Corrugated |
Wire diameter | 0.25 mm |
Aggressiveness | Hard |
Suitable for satin finisher (point system) | 4 of 4 points |
Max. rotation speed | 8000 rpm |
EN standard | 1083-2 |
Last viewed
Overlapping cover cap, for hexalobular socket and AW drive
Full-vision goggles Acetate
1/2" socket wrench insert For TX screws, short
Conical brush Braided steel with M14 connecting thread
HSCo centre drill bit For carbide cylinder saw Heavy Duty
Thin sheet metal screw With hexagon head DBS
Electrician's helmet SH-E 2000-S
Nozzle for HES 510
Hexagon head bolt DIN EN 14399-4, steel 10.9, hot-dip galvanised (hdg), for high-strength structural bolting assembly
Polystyrene sealing plug