Rubber valve for scooters SNAP-IN
Angled tyre valve for motorcycle, small cylinder
TYRVLVE-CART-FOR-11.5MM-RIMHOLES
Register now and access more than 125,000 products
Snap-in valves allow for an extension of a max. of 10 mm
Max. working pressure (DIN 7780): 4.5 bar (at +23°C)
When disassembling and reassembling the internal mechanism, make sure there are no air leaks after inflating the tyre
Datasheets(X)
Instructions for correct fitting of Snap-in rubber valves
- check that there are no sharp or rusty edges on the hole in the rim
- lubricate the valve with plenty of tyre fitting paste or liquid lubricant
- place the valve into the hole in the rim and pull with suitable tools until it slots perfectly into place
Length | 32 mm |
Length (bent length) | 30 mm |
Suitable for rim-hole diameter | 11.3 mm |
Max. length elongation | 10 mm |
Max. operating pressure | 4.5 bar |
Conditions for operating pressure | at 23°C, DIN 7780 |
Material | Rubber |
Design | 90°, Curved |
Suitable for vehicle type | Scooter |
DIN | 7780 |
Product weight (per item) | 15.415 g |
Last viewed
Scratch-resistant visor
1/4 inch socket wrench insert, metric short
Impact drill SB 13-XE
ASSY® 4 A2 CS fittings screw A2 stainless steel plain full thread countersunk head
Sealing ring assortment, mixed 425 pieces in system case 4.4.1.
Storage box (empty)
Pipe and fastening clamp Multifix
Bodywork file blade
Tube belt sander assembly RBS 650
Screwdriver handle with hex bolster