Ribbed nuts Zinc-nickel, transparent passivated with sealing for frame screws
Steel 10 zinc nickel
NUT-HEX-FLG-10-WS19-(P3E)-M14X1,5
Register now and access more than 125,000 products
From M12 with fine thread (thread pitch 1.5 mm)
Chromium(VI)-free
Complies with the EU End of Life Vehicles Directive
Corrosion resistance
Approx. 720 hours of base metal corrosion according to DIN EN ISO 9227-NSS
The specified corrosion resistances apply for the corrosion tests according to DIN EN ISO 9227-NSS (salt spray mist testing), at the earliest 24 h after coating in the “as coated” state, i.e. before sorting, packaging, transporting and/or assembly. These values can be reduced through inevitable handling and assembly processes. A transfer of the corrosion resistances from the salt spray mist test to real assembly and operating conditions is not possible in the majority of cases. When designing a connection, both the combined materials and any coatings and the environmental conditions during operation must be considered by the designer when selecting a suitable corrosion protection coating.
Working principle of locking ribs:
During tightening, the locking ribs roll the counter-material in the area of the nut contact surface. This causes a plastic deformation that hardens the surface. No significant settling is determined at the end of tightening. The locking ribs limit the amount of settling of the connection and therefore reduce the loss of pretensioning force.
Datasheets(X)
CAD data (available after login)
 | |
Thread type x nominal diameter x pitch (D) | M14 x 1.5 |
Height (h1) | 14 mm |
Flange diameter (dc) | 27 mm |
External drive (s1) | WS19 |
Design | With flange |
Standards | WN 2639 |
Material | Steel |
Property class | 10 |
Surface | Zinc nickel |
RoHS-compliant | Yes |
Corrosion protection period | 720 h |
Locking device operating principle | Ribs |
Locking function | Locking against self-loosening by mechanical interlocking |
Thread form | Fine pitch thread |
Last viewed
Transition coupling
Thin-walled heat-shrink hose Shrink rate 2:1 without internal adhesive
T-handle 2C hex key with ball head with side drive
Hexalobular screw with flattened half round head
Bath sealing tape Complies with DIN 18534-1
Twist drill bit HSCo DIN 1869 R3 type RN
Wood screw, DIN 96 Half moon head with slot
Taper-grooved dowel pin ISO 8745 steel plain
Flat-head screw with H cross recess ISO 7045, steel 4.8, zinc-plated, blue passivated (A2K)
Countersunk screw with hexalobular head