Puller tool
Extractor tool
EXTRTL-(195-62MM)-10T
Register now and access more than 125,000 products
- Cross-beam adjustment via hexagon nuts on pull legs
- Malleable cast iron cross-beam
- Nitrocarburised spindle
- High-strength legs
Datasheets(X)
After separating, the legs of the puller tool are screwed into the separating blade and the cross-beam is mounted. The spindle is screwed against the shaft. The part being extracted is pulled off gently and securely by tightening the spindle against the end of the shaft.
Last viewed
1/2 inch torque wrench with push-through ratchet
Hand tap, third tap HSS DIN 352
Twist drill DIN 340 HSS type RN
Hexagonal bolt with thread up to the head DIN 933, A2 stainless steel, plain
Screwdriver TX 3C handle with round shank
Hexagon Socket Head Cap Screw with centre, with low head DIN 6912, steel 8.8, zinc-plated blue passivated (A2K)
Pan head tapping screw, shape C with AW drive
Cordless hand-held circular saw AHKS 18-68 COMPACT M-CUBE
Sealant smoothing agent
ASSY® 4 CSMP universal screw Steel zinc plated partial thread countersunk milling pocket head