Protex Anti-tannin
Water-based wood impregnation, Protex anti-tannin
WOPROT-PROTEX-ANTI-TANNIN-5LTR
Register now and access more than 125,000 products
Characteristics
- Water-based single-component
- Film with transparent appearance
- Tannin inhibitor
- Easy to apply with a brush
- Excellent bonding
- Excellent elasticity
- Maximum penetration
- Quick drying
- Especially recommended for hard and tropical woods
- Fungicide and insecticide protection
- Excellent ageing outside
- Application by gun (manual, airless, airmix or robot)
- No strong odour during application
- Open pore
- The drying time refers to air circulation and relative humidity conditions that aid gradual evaporation of the water
- In case of rain or high humidity, a white film may appear, which gradually disappears as the water evaporates
- For professional use only
Datasheets(X)
- Shake before use to mix the product thoroughly
- Fully sand raw wood for good penetration and bonding
- Clean the dust and dirt from the surface to be treated
- Apply 1 or 2 coats
- Colour intensity depends on the type of wood and the number of coats applied
- Add water to lower the viscosity of the product
- Do not apply the product at temperatures below 12ºC and humidity greater than 85%
- Tool: Manual, robot, electrostatic, airless, airmix gun
- Solvent: water
- Weight %: 5–10%
Contents | 5 l |
Colour | Colourless |
Container | Canister |
Conditions for drying time | at 20°C and 60% relative humidity |
Drying time | 3 h |
Shelf life from production | 12 Month |
Min. processing temperature | 12 °C |
Shelf life from production/conditions | 12 Month / at 5°C to 35°C |
Last viewed
Half-shell hexagon crimping insert
AL 20 short plate pair
Terminal board in polyamide 6.6
Circlip for bore hole, standard version, shape J DIN 472 for bore holes, spring steel, phosphated and oiled
Rubber hammer, shape A DIN 5128
Flat washer with chamfer for high-strength fittings
Hexagonal bolt with shank SB FITTINGS DIN EN 15048-1 ISO 4014, steel 8.8U, hot-dip galvanised, with nut ISO 4032
Reinforced clamp
ASSY® 4 CSMP universal screw Steel zinc plated partial thread countersunk milling pocket head
Case