Hot-melt edgebanding adhesive for industrial machines
For detailed information, other images and documents, please select individual articles from the following table.
Hot-melt edgebanding adhesive for industrial machines
For automatic roller edging.
Exclusively for trade customers
Register now and access more than 125,000 products
Variants
Exclusively for trade customers
Register now and access more than 125,000 products
EVA copolymer granules
Flexible and transparent
- No joint marks.
Excellent adhesion
- Clean application
Leaves no threads
- No edge inlays when edge cutting
- Does not contaminate machine parts
High strength
NoticeRecommended speed: 10-30 m/minute (depending on the edge width)
Application temperature: 170 to 200 °C
Softening point: approximately 105 °C
Application temperature: 170 to 200 °C
Softening point: approximately 105 °C
This information is based on our own experience. We recommend performing a test first. Due to the wide range of applications, and storage and handling conditions, we take no responsibility for the result of a specific application. We assume no liability for the information and technical advice provided by our customer service team, except where the advice or information provided falls within the scope of the contract or where the advisor has acted deliberately in bad faith. We guarantee the consistent quality of our products and reserve the right to make technical modifications and further developments.
Application areaFor edging polyester, melamine, PVC, ABS, solid wood and plywood, as well as non-pressed impregnated paper.
InstructionsClean the surface and remove any dust. Make sure the surface and edge are at room temperature, ideally 18 °C. The wood moisture content should preferably be between 8 and 10 %. Avoid drafts when working.
Check the temperature regularly and adjust if necessary. Adjust weight so the adhesive bubbles slightly at the edges.
The bonded material can be machined immediately after joining.
Check the temperature regularly and adjust if necessary. Adjust weight so the adhesive bubbles slightly at the edges.
The bonded material can be machined immediately after joining.
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!