For detailed information, other images and documents, please select individual articles from the following table.
Consolidating impregnation for construction
Water-based nanoparticle sealant with high penetration into porous mineral substrates.
Register now and access more than 125,000 products
Variants
Register now and access more than 125,000 products
Features
- Impregnation for the hardening and consolidation of degraded or non-cohesive surfaces of mineral-derived materials such as cement, plaster, tempera, perlite, vermiculite, monolayers and other heated or dusty substrates.
- 1-component, odourless and non-yellowing product.
- Compatible with alkaline concrete substrates.
- Cement alkalinity sealant.
- Hardening of bricks that are under-burnt or subject to salt damp, and absorbent stone (clay, sandstone etc.).
Advantages
- Improves adhesion and performance of subsequent layers by acting as a sealant.
- Can be applied indoors and outdoors.
- Easy application, product ready to use. Do not dilute.
- Fast drying and repainting.
- Resistant to fading, water absorption, dirt and alkalinity.
- If necessary, a water-repellent treatment can be applied.
- This reduces the formation of efflorescence in the substrate, but does not solve the problem definitively when water pressure persists.
- Permeable to water vapour
Benefits
- Reduces soiling and splash stain problems.
- Saves time during application thanks to its ease of use
- Exceeds current environmental regulations.
These instructions are merely recommendations based on our experience. We recommend performing tests for each new type of application or surface to be treated.
Can be applied with brush, roller, air gun or airless spray gun. Before application, thoroughly mix the product at low speed. Surfaces must be adhered, integrated, consistent, dry, and clean from grease, dust, work debris, old paint, salt etc. On a clean substrate, spread the product saturating the surface so that the pore of the absorbent surface is sealed and completely closed. Apply a second coat on highly absorbent surfaces.
Precautions for use
Do not apply at temperatures below 5°C or above 40°C.
Avoid use when rain is forecast 4-5 hours after application.
The product slightly increases the intensity of the substrate's tone.
Avoid buildup or thickening of the product that may impair its transparency.
Pre-test before repainting with solvent products.
The amount of product required may differ depending on the application system (brush, wool roller, spray, airless spray gun at a distance of 10 cm from the substrate). Consult the technical department when applying the product in special situations.
Clean tools with water immediately after use.
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!