For detailed information, other images and documents, please select individual articles from the following table.
Register now and access more than 125,000 products
Variants
Register now and access more than 125,000 products
- Temporary edge protection system, class A, in accordance with UNI EN 13374:2019
- The edge protection system enables safe work on flat or inclined surfaces made of reinforced concrete (maximum incline below 10°) on buildings or other structures. It is capable of supporting a person who leans on the protection whilst walking and it stops the person from falling in the direction of the protection itself
- Bracket consisting of two parts, one inside the other, which can be slid thanks to a threaded rod
- Clamp consisting of a fork made from folded sheet metal and a plate, one inside the other, which can be slid thanks to a threaded bar
- Useful height of the bracket measured perpendicular to the work surface: 1 m
- Made of steel S 235 JR G2, zinc-plated
Certifications:
Calculation report: ref. RDC-PT-W-1 dated 01/07/19
Conformity assessment: ref. 0899964730(WA-10) dated 01/07/2019
Before installing the temporary guardrail, ensure that the structure to which it will be fitted is capable of absorbing the loads transferred by the bracket to the anchor point (see point 5 on page 4 of the instruction booklet)
Opening the clamp fully makes the two parts of the bracket come apart. Take care in order to avoid accidents during installation! (Risk of one of the two parts of the bracket falling from a height!)
To prevent the bracket from coming away from the anchor point, make a hole with Ø 14 mm and a min. depth of 60 mm on the inner bend of the upper fork and dry-fit a steel rod with Ø 12 mm x 100 mm (see fig. 1 on previous page) Cover the protruding part of the rod with a protective cap
Incorrect use of the temporary guardrail could cause a fall or accident. Therefore, please read the instruction booklet carefully before using the equipment for the first time
Conditions of use and limits
- Maximum usage height from the ground: 40 m
- Wind speed no greater than 30 m/s
- Work surface gradient below 10°
- The tilt of the guardrail must not deviate from vertical by more than 15°
- Maximum distance between two brackets: 1600 mm
- Insert spruce wood planks or other planks (minimum class C16 - UNI EN 338) into the appropriate brackets
- Size of planks for the handrail, intermediates and toe board: 150 x 25 or 150 x 30 mm
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!