Power spray glue plus
Power spray adhesive Plus
SPRADH-POWER-PLUS-400ML
Register now and access more than 125,000 products
Excellent heat resistance up to 110°C 1)
Long-lasting secure hold in a variety of applications
Fast-drying
Shorter processing time, as further processing of the material can occur more quickly
Spray head adjustable in 2 positions
- Horizontal and vertical
- Spray jet width
- Extremely flexible in a wide variety of working situations thanks to the optimum setting and application options
Transparent hardening
- Colourless bonding
- No colour seepage due to transparent curing with thin adhesive application
1) Depending on the testing method
After use, turn the can on its head and spray until the valve is empty.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet!
Datasheets(X)
Suitable for gluing fabric, polyether/polyester foam, foam rubber profiles, insulation materials, roof lining material, leather, felt, cardboard (together or onto rubber), metal (raw, phosphated, annealed, primed and painted, anodised), wood materials and polyester materials. Also suitable for gluing PE film (e.g. as sheeting for spray water protection inside car doors). This spray adhesive can also be used for finishing purposes and for linings (car roof linings).
Thoroughly clean surfaces to be adhered and then spray them. Spray absorbent surfaces until they are saturated. The spraying distance should be approx. 15–25 cm. Allow to flash off for between 5–15 min. (depending on temperature, material and application) and join.
For more information, please refer to the technical data sheet.
Chemical basis | Synthetic rubber |
Colour | Transparent |
Density | 0.85 g/ml |
Smell/fragrance | Characteristic |
Min./max. processing temperature | 0 to 30 °C |
Min./max. temperature resistance | -20 to +110 °C |
Min. flashing point | -24 °C |
Min./max. flash-off time | 5 min-15 min |
Min./max. spraying distance | 15-25 cm |
Contents | 400 ml |
Weight of content | 288 g |
Min. combined tension and shear resistance | 0.26 N/mm² |
Shelf life from production | 12 Month |
Silicone-free | Yes |
Last viewed
A 402 door handle
Plus Quadro-L Vario hammer drill bit
PTFE thread-sealing tape
Wago screwless connection terminal For all types of copper wire
Pan head tapping screw, C shape with H recessed head DIN 7981, steel, zinc-plated, blue passivated (A2K), shape C, with tip
Circular saw blade, wood For hand-held circular saw HKS 52
Wall and ceiling grinder WSS 225-E COMPACT
Hexagonal bolt, with thread to head and fine thread DIN 961, steel 8.8, zinc-plated, blue passivated (A2K)
Dirt blaster
Pneumatic impact screwdriver DSS 1 inch P