Plug connector reduced For commercial vehicles
Push-in qck-actn plg cnctn, reducing plug-in cnctr
QCKPLGCON-REDUC-(D12-8MM)
Register now and access more than 125,000 products
Quick and easy pipe/hose installation and removal
Reduced risk of leaks
as there are fewer components
Corrosion-resistant brass design
Cost savings
thanks to reduction in installation and repair times
Complies with the international DIN, DOT and SAE regulations
Operating medium:
Compressed air
Maximum operating pressure:
In accordance with DIN 74324
Operating temperature:
-40°C* to +100°C (* at temperatures below +2°C please observe the air quality)
Hoses:
In accordance with DIN 74324
Material:
- Connector body: Brass
- Pipe reinforcing sleeve: Brass, nickel-plated
- Multi-pronged tensioning clamp ring: Brass, nickel-plated
- O-ring: Buna N (low nitrile)
Above a certain length, pipes "vibrate", irrespective of whether they are made of steel, copper or plastic. Therefore, all brake line piping (5–16 mm diameter) should be secured on the body or on the frame using pipe clamps, rubberised if possible, wherein the distance should be 1 m and must not exceed 1.20 m.
Screw connections meet the requirements of DIN 74324
Screw connections meet the requirements of the Department Of Transport Federal Motor Vehicle Safety Standard (DOT FMVSS 106) and the Society for Automotive Engineers (SAE J1131)
Screw connections are TÜV tested and approved for use in pneumatic brake systems
on commercial vehicles
Datasheets(X)
- For polyamide pipes Ø 6 to 16 mm
- For connecting components in the pneumatic brake system on commercial vehicles and auxiliary commercial vehicle systems
Length (L) | 48.5 mm |
Material | Brass |
Last viewed
Sweat band For the back of the head
Halogen-free rigid pipe 4422
1/2" socket wrench insert For TX screws, short
Speed cutting disc For stainless steel
Diamond cutting disc Super Cantero Evo
Ash handle
Paint tank for ADVANCE W9 gun
Threaded pin For furniture castors
Hexagonal bolt, with thread to head and fine thread DIN 961, steel, strength class 10.9, zinc-nickel-plated, transparent passivated (P3E)
Dust-free sanding system foam adapter