Plaster microspheres
Filler ready-to-use with microspheres
PORFILR-WATERBASE
Register now and access more than 125,000 products
For indoor and outdoor use
Can be applied to surfaces such as plaster, concrete, cement, wood, polyethylene etc. both indoors and outdoors.
Does not shrink.
Specially formulated so it does not shrink, crack or peel, thanks to its microspheres and excellent adhesion.
Can be painted immediately
Dries quickly so it can be painted on immediately, except with solvent paints.
Easy to sand
Extra easy sanding with minimal effort, achieving an extra white finish. Allows drilling and nailing in repaired areas.
These instructions are merely recommendations based on our experience. We recommend performing tests for each new type of application or surface to be treated.
Datasheets(X)
The surfaces to be treated must be clean, dry and free from grease.
Apply pre-primer (Impromax) on highly absorbent surfaces.
For stucco, dilute with water and remove it until a uniform, moist paste is achieved.
Apply with a trowel or spatula.
Clean the tools with water after you have finished working and seal the product tightly.
Do not apply the product on surfaces subject to permanent moisture.
Do not apply the product at temperatures below 5°C.
This product is exempt from safety labelling
Contents | 4 l |
Shelf life from production | 36 Month |
| Technical data | |
| Composition | Light loads and acrylic copolymers |
| Thinner | Water |
| Density | 0.4 + 0.05 g/cm³ |
| Form | Paste |
| Colour | Very white |
| Can be coloured | Supports universal or water-based colourants up to 4 % |
| Granulometry | < 200 P: Fine |
| Application | |
| Application temperature | Between 5°C and 30°C |
| Tool | Smooth trowel and spatula |
| Tool cleaning | With water immediately after use |
| Maximum thickness | Any thickness |
| Working time | No limit |
| Theoretical consumption | Variable according to thickness and environmental conditions |
| Painting | Can be painted with plastic paint after approx. 2 hours. For solvent-based paints, wait 24 to 48 hours. |
Last viewed
1/2 inch socket wrench insert metric, hexagon, short
Wrench For nozzles
H70 diamond socket cutter
Concealed hinge, TIOMOS click-on 110/30 E With integrated damping, three damping settings available
LED panel UGR<19
Jump starter, 12/24 V
HSS annular cutter
Cross-line laser CLG 18
Hexagonal nut with clamping piece (all-metal) DIN 980, steel 8, zinc-plated, blue passivated (A2K)
Centre drill bit For hammer core drill bit