Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X65X85MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
Last viewed
Lock nut DIN 7967, zinc-plated steel, blue passivated (A2K)
Bonded anchor mortar cartridge W-VD
Bond + Seal structural adhesive
Sleeve for halogen-free rigid pipe LH IP67
C 8.0 TX bit (5/16 inch) C 8.0 (5/16 inch)
1/4-inch socket wrench For internal 5-star screws
3/8" socket wrench With multi profile, hexagon, short
Flat folding filter, paper For ISS series
Occupational shoe Caracas O1 ESD
Universal thinner For almost all solvent-based paint and primer materials