Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X65X75MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
 | |
Suitable for door handle | DH A 610 FS, DH A 802 FS, DH A 803 FS, DH A 807 FS, DH A 810 FS, DH A 811 FS |
Material | Steel |
Surface | Zinc plated |
Length 2 (L1) | 65 mm |
Length 3 (L2) | 75 mm |
Length (L) | 140 mm |
Square size | 9 mm |
DIN direction | DIN R/L |
Standards | DIN 18273 |
Last viewed
Internal lens for Solar
Metric combination wrench with POWERDRIV®
Screw cap for number plate screw
Flat square For FB windowsill duct
Angle grinder EWS 12-125 SOLID
Countersunk tapping screw shape C with H recessed head DIN 7982, steel, zinc-plated, blue passivated (A2K)
ASSY® 4 RCS fittings screw Steel brass-plated full thread raised countersunk head
1/2 inch socket wrench insert metric, hexagon, short
NC machine reamer HSCO WN, H7 universal
ZD 403 lockable window handle