Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X60X70MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
 | |
Suitable for door handle | DH A 610 FS, DH A 802 FS, DH A 803 FS, DH A 807 FS, DH A 810 FS, DH A 811 FS |
Material | Steel |
Surface | Zinc plated |
Length 2 (L1) | 60 mm |
Length 3 (L2) | 70 mm |
Length (L) | 130 mm |
Square size | 9 mm |
DIN direction | DIN R/L |
Standards | DIN 18273 |
Datasheets(X)
Last viewed
Maintenance set 9 pieces
Fixing clamp
1/4-inch bit drill holder
Metric combination wrench with POWERDRIV®
Cable tie KBL 1 made of polyamide with plastic tongue
Holder For small abrasives
3/8 inch socket wrench insert metric, hexagon, short
Sanding Plate D 150 mm For ETS 150-E twin random orbital disc sanders
Allen key set, hexagon socket 9 pieces
50 % organic radiator anti-freeze G12
