PVC adhesive gel
PVC gel adhesive in pot
ADH-PVC-CAN-1000ML
Register now and access more than 125,000 products
Suitable for distribution, supply and sewage systems
Versatile adhesive supplied with integrated brush
Gel formula
- Easy application
- Does not run, no streaking effect inside bonded tubes
High apparent viscosity and excellent fluidity
Very good adhesion on the parts for bonding
Moderate initial setting time:
- Withstands minor variations in movement at the time of installation
- Facilitates bonding of large parts
Acts as a true PVC chemical weld
Very good torsion and traction resistance
Ageing comparable to that of rigid PVC
Strong, typical odour
Pressure resistance (20°C) 51.2 bar and (40°C) 20.8 bar
Compliant with Standard NF EN 14814
Specially developed to bond materials that meet Standards NF EN 1452 and NF EN 1329
Adhesive approved for thermoplastic pipeline systems for pressurised fluids up to PN 16
Certified by the Lyon Environmental Health Laboratory (CARSO) and by the CSTB (Centre Scientifique et Technique du Bâtiment — French scientific and technical centre for construction) (Certificate QB 14 - AD02) for use in drinking water networks
Compliant with Standard NF EN 14814
Specially developed to bond materials that meet Standards NF EN 1452 and NF EN 1329
The usage instructions are recommendations based on our own experience. Carry out a preliminary test. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our contractually agreed service or the advisor was acting deliberately. We guarantee the ongoing quality of our products. We reserve the right to make technical changes and other developments.
Hazardous. Follow the precautions for use
Datasheets(X)
Useful for plumbers, heating engineers, pipe maintenance workers, public construction products
Based on a polyvinyl chloride (PVC) resin, this PVC adhesive gel has been developed specifically for rigid PVC pipe joints and accessories in installations under pressure up to PN16
Suitable for bonding water supply pipes, irrigation pipes, gas pipes, industrial pipework and rainwater and sewage pipes
For best bonding performance, prepare surfaces properly. Clean and degrease the tube and connector using Würth PVC cleaner. Apply the adhesive using the brush, in the inside to outside direction, forming a thin layer on the connector and on the tube. Hold in place for 30 seconds for the adhesive to form the initial bond. Clean away any surplus with a cloth soaked in Würth PVC cleaner. The drying time varies depending on the climatic conditions.
Can be handled after 10 min.
Drying time for drainage systems: approx. 1 hour.
Drinking water systems pressurised after 24 hours.
Weight of content | 970 g |
Colour | Yellow |
Smell/fragrance | Characteristic |
Min./max. processing temperature | -5 to 30 °C |
Contents | 1000 ml |
Last viewed
Type S lock washer assortment 1,220 pieces in system case 4.4.1.
Radiator paint brush DW light For dispersions and wall paints
Nail UNS 104 In accordance with DIN EN 206
Blind rivet, large flat head
Hexagon nut with fine thread DIN 934, steel I10I, plain
Wallpaper smoothing brush With a mixture of China and polyester bristles
Brass anchor
LED panel UGR<19
Paper roll
Superglue set, 3 pcs