Nylon® anchor for square cable tie
Cable tie plug-in anchor with retainer
PLGINANC-CBLTIE-KST-W.RTNR-BLACK-8X43
Register now and access more than 125,000 products
Technical data
- Material: polyamide 6.6/Nylon®.
- Supports cable ties up to 9.5 mm wide.
- Halogen-free.
- Natural and grey (RAL 7035): for indoor use.
- Black: resistant to ultraviolet rays and weather conditions. Due to the carbon particles it contains, the effect of ultraviolet radiation is reduced.
Version without wings
- The head of the anchor is designed to ensure perfect cable tie retention.
Instructions for use
- For assembly, drill the fixing base using a drill bit of the specified diameter and insert the anchor by striking it with a hammer.
Datasheets(X)
Suitable for cable ties | max. 9.5 mm |
Drill hole diameter | 8 mm |
Min./max. temperature conditions | 0 to 85 °C |
Material | PA - Polyamide |
Head height | 6.5 mm |
Width of head | 9.7 mm |
Length | 43.5 mm |
Last viewed
1/4 inch socket wrench insert, metric short
Nozzle For manual riveting tool
Drilling screws
Concealed hinge, TIOMOS click-on 110/37 A With integrated damping, three damping settings available
Metric combination wrench with POWERDRIV®
Hard hat Pro-Tek 6-point
Flat paintbrush For solvent-based lacquer and paint systems
Collet chuck for flexible shaft
Hand tap, second tap HSS DIN 352
Powerglider with special eye head