Nail HNS 103/18 In accordance with DIN EN 206
Nail HNS 103/18
NL-HNS103-DISC18MM-27MM
Register now and access more than 125,000 products
Improved drive-in properties thanks to "loose" washer structure
Length calculation for nails used on concrete substrates:
Penetration depth (min. 25 mm/max. 40 mm) + thickness of component to be fastened = nail or shank length
Length calculation for nails used on steel substrates (min. thickness 5 mm):
Penetration depth (min. 8 mm/max. 12 mm) + thickness of component to be fastened = nail or shank length
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material of nail | Steel |
Surface of the nail | Zinc plated |
Material of washer | Steel |
Surface of the washer | Zinc plated |
Washer thickness | 2 mm |
Shaft length (SL) | 27 mm |
Shank diameter (Øds) | 3.7 mm |
Washer diameter (ØS) | 18 mm |
Head diameter (Ødk) | 8 mm |
Suitable for device type | Würth BST 350, Hilti DX 2, Hilti DX A40, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Clamping pin/clamping sleeve, slotted, heavy-duty design ISO 8752 spring steel plain
Metric combination wrench with POWERDRIV®
Malleable iron screw clamp with 2C handle
HSS annular cutter
Wing repair washer According to DIN 522, zinc-plated steel, blue passivated (A2K)
Solvent for polyurethanes
Hexagon Socket Head Cap Screw with low Head DIN 7984, steel 8.8, plain
Hexagonal bolt with shank DIN 931, steel 12.9, plain
1/2" socket wrench insert For TX screws, short
System insert 8.4.1, double open-end wrench