Multi-purpose carbide drill bit
Multi-purpose carbide drill bit Plus mounting
DRL-GENPURP-TC-PLUS-D8-L160-WL100MM
ZEBRA
Register now and access more than 125,000 products
Ideal for splinter-free drilling into tiles, precise anchor holes in bricks for a secure hold, wood/masonry connections, iron reinforcements in concrete etc. Guarantees optimum drilling results thanks to multi-purpose cutting geometry.
SDS mount
Technical features
- Diamond-ground carbide cutting blade
- Permanent connection between carbide panel and quenched and tempered special steel thanks to high-temperature soldering process
- Highly accurate tapping, even on hard surfaces, thanks to cut chisel edge
- High resistance to wear thanks to quenched and tempered special steel
Only use the tool in rotating mode
Datasheets(X)
Tiles up to scratch hardness 7–8, ceramic, marble, asbestos cement, clinker brick, aerated concrete, vertically perforated brick, lightweight construction materials, plastics, wood, coated panels, soft steel, cast metal, iron reinforcements in concrete where permitted in accordance with structural design considerations.
Diameter (Ø) | 8.0 mm |
Length | 160 mm |
Working length | 100 mm |
Tool holding device | Suitable for SDS-plus |
Last viewed
Customer-ordered assortments
ASSY® 4 CS fittings screw Steel zinc plated full thread countersunk head
Polycarbonate face shield
Bevelled-edge chisel In accordance with DIN 5139
Ratchet with twist handle 1/2''
Glazing packer assortment For long-lasting, professional block setting of glazing units
Wooden shaft, conical With ground cone and rounded shaft end
Combination wrench set, extra long 12 pieces
1/4 inch socket wrench insert, metric short
Pan head screw with Z cross recess DIN 7985, A4-70 stainless steel, plain