Masonry connectors/flat tie rod Stainless steel, material no. 1.4401, 1.4571, 1.4362 in line with DIN 17440
Wall connector/flat tie rod, A4 stainless steel
MNCON-V4A-300X15X0,5
Register now and access more than 125,000 products
Only approved for horizontal installation.
It is essential to observe the information on calculation and processing found in the approval.
Technical approval Z-17.1-711
Datasheets(X)
- Masonry connectors must be embedded completely in the joint. To ensure this, insert the connector halfway up the joint and cover the top with mortar
- Minimum joint thickness 2 mm (for masonry constructed using the thin bed method)
- Install perpendicular between the end faces of the walls being connected
- Butt joints between walls running at different angles must always have mortar applied across the entire thickness of the wall
- Minimum bond length: 140 mm
Material | Stainless steel |
Surface | Anodised |
Length | 300 mm |
Width | 15 mm |
Thickness | 0.5 mm |
Type description | MV-III |
Colour | Stainless steel coloured, Chrome coloured |
Last viewed
1/4 inch bit adapter With quick-change chuck
Gas cartridge For DIGA® CS-2 POWER and DIGA® CS-3
Fabric sanding belt Synthetic corundum for electric grinding file
Twist drill bit HSS DIN 338 type RN 118°
ASSY® 4 COMBI timber screw Steel zinc plated partial thread hexagon head
Portable bandsaw PBS 120 - AUTOMATIC
Jump starter, 12/24 V
Hand tap, third tap HSS DIN 352
Hook and loop support plate
Double-ended socket wrench