MS 5000 disconnect pin For turning knob
Disconnect pin
DISCONPIN-F.FRNLOK-MS5000
Register now and access more than 125,000 products
Disassembly of interchangeable core cylinder. If there are decorative buttons, use a screwdriver to pierce the plastic cap in the middle of the head and pull the cap out. Insert the screwdriver through the cylinder housing into the oval pouch in the base and turn the adapter so that the pouch is upright over the two holes. Feed the release pin all the way through the hole in the adapter and press lightly on the side of the release pin head to remove the rotary knob.
 | |
Length | 85 mm |
Width | 23 mm |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
Hammer-resistant lightweight core bit
Double-sided transfer tape
Hexagonal bolt with thread up to the head DIN 933, steel 8.8, zinc-plated, blue passivated (A2K)
1/4" socket wrench insert metric, long
Fabric sanding belt Zirconia alumina electric grinding file
Safety screw
Hole puncher assortment 12 pieces with manual hydraulic punch
Occupational shoe Ultra X OBE
Metric double open-end wrench DIN 3110/ISO 1085
1/2 inch socket wrench insert metric, hexagon, short
