Locking sealant with high resistance to loosening
High-strength sealant for pipes
TUBE SEALANT FOR GAS AND HOT WATER
Register now and access more than 125,000 products
Seals immediately up to 5 bar
Sealed fittings can withstand up to approximately 5 bar. After the final curing, they can withstand pressure up to the bursting pressure of the pipes
High-strength anaerobic sealant
- For metal fittings up to 2"
- Replaces PFTE tape and hemp
- Single-component products, designed for concealed systems, first installations and maintenance where subsequent disassembly is unlikely
- Can be used on steel pipes, brass, and galvanised, nickel-plated and chrome-plated surfaces
- Not suitable for copper pipes
Approved
- Certified by the German Technical and Scientific Association for Gas and Water (Reg. no. NG 5146AT0298)
- DIN EN 751-1 tested for airtight, gas-tight and watertight properties
| Fitting description | Gas (methane and LPG) | Water from +40 to +95°C |
| Copper | NO | NO |
| Brass | YES | YES |
| Polished steel | YES | YES |
| Galvanised steel | YES | YES |
| Hot-dip galvanised steel | YES | YES |
| Malleable cast iron | YES | YES |
Approved
- Certified by the German Technical and Scientific Association for Gas and Water (Reg. no. NG 5146AT0298)
- DIN EN 751-1 tested for airtight, gas-tight and watertight properties
Datasheets(X)
Sealant for threaded pipes and fittings that prevents leakage of gases and fluids such as:
- Methane and LPG
- Hot and cold water
- Refrigeration system gases and fluids
Use acetone to thoroughly clean the surfaces to be assembled. Apply the sealant to half of the male thread and half of the female thread to be assembled. Once the alignment is correct, do not reposition the connector
Weight of content | 100 g |
Chemical basis | Methacrylic acid ether |
Colour | Violet |
Min./max. functional strength | 2-3 h |
Max. final strength | 24 h |
Min./max. temperature resistance | -50 to 150 °C |
Min. flashing point | 100 °C |
Last viewed
Dust extraction For socket cutters without quick-change function
Hexagonal bolt with shank ISO 4014, steel 10.9, zinc flake, silver (ZFSHL)
Puller screw (high strength) DIN 961, steel 10.9, plain
Laser measuring gauge test case for axle reference measurement 49 pieces
1/2 inch impact socket wrench insert hexagon, metric, short
ELMO® device screw box
VDE screwdriver, flat slotted
PinPuller® copper electrode
Chemical anchoring WIT-EA 150
Universal cleaner R1