Light sheet metal rail Aluminium (EN-AW-6063 T6)
Sheet metal rail Light
SHTMETRL-SOL-ALU-TRAPEZE-25X80X3150MM
ZEBRA
Art.-no.
0865726315
EAN 4053479041186
Prices for customers after login
Exclusively for trade customers
Register now and access more than 125,000 products
For mounting directly on the trapezoidal sheet
Notice
- Not suitable for flat roof elevation mounting
- It should be ensured in advance that the sheet metal is sufficiently attached to the substructure. The maximum load-bearing capacity of the sheet metal should also be checked. Approval must be obtained from the manufacturer, particularly in the case of sandwich roofing elements. We recommend using ZEBRA® DBS® 4.5 x 25 thin sheet metal screws with sealing washer for attachment. The sheet metal rail must be pre-drilled with Ø 5.0 mm holes.
Product information
Datasheets(X)
 | |
Length | 3150 mm |
Height | 25 mm |
Width | 80 mm |
Material | Aluminium |
Last viewed
Gas cartridge For DIGA® CS-2 POWER and DIGA® CS-3
Base for clip hinge SERIES 1
Hexagon socket set screw with pin ISO 4028, A2 stainless steel, 21H, plain
Resettable fuse ATO set For continuous operation (fixed installation) and fault finding (diagnosis)
Threaded bushing For repairing car spark plugs, TIME-SERT®
LED transformer with wireless RGB controller
Reinforced rubber hose For one-handed, two-handed grease gun and lever grease gun
U-clip, type 1
Rotating beacon dome
Hexagonal bolt, fully threaded, SB fittings, DIN EN 15048-1