Laminate end clamp For frameless photovoltaic modules (laminate modules)
Laminate end clamp, preassembled
RTNGCLIP-SOLCOLL-END-ALU-6,8MM-SW13
ZEBRA
Register now and access more than 125,000 products
Fully pre-assembled
The end clamp can be attached straight to the mounting rail without any preparatory work
Only suitable for mounting crosswise!
Certified by First Solar, Calyxo and Q-Cells
Datasheets(X)
 | |
Suitable for module height | 6.8 mm |
Grip distance between the modules | 16 mm |
Grip width | 80 mm |
Material | Aluminium |
Surface | Plain |
Suitable for mounting rail | 47 x 37 mm, 60 x 37 mm, 70 x 44 mm, 120 x 90 mm |
Last viewed
Zinc clip-on wheel weight For car aluminium rims
Hand tap set HSS, DIN 352 3 pieces
Twisted rod For rivet nut setting pliers HES 510
Floor guide
VM 175 full face mask
NP profile short cylinder In 6-pin system
Suction hose, clip-on For ISS and TSS series
Open-ended wrench
Deep groove ball bearing
MFD-S multi-purpose drill bit with straight shank