GEFU® thread-rolling screw With flat head and hexalobular drive (Txplus), serrated
GEFU DIN 7500-1 steel zinc plated flat head TXP
SCR-PANHD-UKV-TXP20-(A2K)-M4,0X9
Register now and access more than 125,000 products
For a secure connection in thin sheet metal (up to approx. 520 N/mm²):
- Thread-cutting zone for forming rim holes
- Special round under-head geometry for high tightening and overturning torques
- Play-free and self-locking thread seating => Reduced likelihood of screw working loose => Protection against loss
- Toothing under the head for increased breakaway torque
The suitability of the GEFU for the application or component in question must be determined by preliminary testing!
1. Apply
2. Thread tapping and creation of eyelet in sheet metal
3. Tighten
| Pre-hole diameter recommendations: | |||
| Nominal diameter | Sheet thickness mm | Pre-hole diameter mm | Tightening torque Nm |
| M4 | 0,5 | 2,6 | 2 |
| 0,6 | 2,9 | 2,7 | |
| 0,85 | 3,1 | 3,2 | |
| All specifications are determined empirically for sheets made of material St12 (tensile strength approx. 350 N/mm²) | |||
Datasheets(X)
For a secure connection in thin sheet metal (up to approx. 520 N/mm²)
Last viewed
Spring-loaded pressure piece with ball
Cylindrical pin, unhardened with oval points DIN 7, plain steel (9 SMnPb 28 k or St 50 K), unhardened, tolerance class m6
Hand-held circular saw, elctrc, spr prts
Insulated flat plug-in sleeve with PVC branch
3/8" cardan joint insert short
Screwdriver TX 3C handle with round shank
Two-hand angle grinder EWS 24-230-S
Order protector with rip-tape fastening
Plastic clip, double
Hand tap, second tap HSS DIN 352