Force multiplier WÜRTH XL3500
Torque multiplier XL3500
WHLFITTAID-3500NM
Register now and access more than 125,000 products
- Makes it easy to remove firmly anchored screws and nuts, for example on truck wheels, public machinery, agricultural tractors and in industry in general.
- Simple and easy to use by a single operator, no levers or auxiliary tools required.
- The set comes equipped with two 32 mm and 33 mm impact sockets, 8 cm long, especially for the multiplier.
- Contains a bar to tighten the nuts as close as possible to the rigid surface.
The Würth force multiplier has been developed for manual operation only. Do not attempt to use it by attaching an air gun, as this could cause serious damage to the air gun and could create an additional risk to the user's safety.
When removing nuts or bolts, take care as the multiplier recoils slightly.
Datasheets(X)
Last viewed
Wiggle wire
Water pressure tank For diamond core drilling technology
Bond + Seal structural adhesive
Polishing pads
Sanding discs ProLine
1-ear clamp with insert ring
Cable tie KBL 1 made of polyamide with plastic tongue
Staples for hand-held stapler and hammer tacker
Lid for paint mixing cup
Expander tool for drop-in anchors, without visual installation control
