Drilling screw, pan head with collar and H cross recess pias®
pias steel zinc flake ZFBM pan head flange H
SCR-DBIT-PANHD-FLG-H2-(ZFBM)-4,8X16
ZEBRA PIAS
Register now and access more than 125,000 products
Drilling, thread forming and screwing in one step, saving considerable time and effort
Exact drilling diameter for any screw connection
- Resulting in minimisation of thread tolerance
- Always an optimum connection
Prevents mistakes in the installation
- The pressed-on flange generates a lower surface pressure, which helps to prevent stress cracks.
- Contact pressure during use approx. 100 N/screw in with depth stop if necessary
- Zinc-plated drilling screws must only be used where dampness is not to be expected.
- For connection elements with a construction product approval, the approval, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
The self-drilling screw for fastening plastic and thin sheet metal to metal sub-structures.
Last viewed
Plastic casing
Hand tap, taper tap HSS DIN 352
Wing repair washer According to DIN 522, zinc-plated steel, blue passivated (A2K)
Distance bushing set 3 pieces
Hexagon shoulder screw with short threaded pin DIN 610, steel 8.8, plain
Adapter A4 for bi-metal cylinder saw for diameters of 14 to 30 mm
Hand pump with hose
Hexagonal bolt, fully threaded, SB fittings, DIN EN 15048-1
Eyelet screw GS
ASSY® 4 CS fittings screw Steel zinc plated full thread countersunk head