Drilling screw, hexagon head with protective cap and sealing washer made of A2 stainless steel pias®
Self-tppng fcd screw pias, A2-head sealing washer
SCR-DBIT-A2HD-WSH19-(A3K)-6,0X38
ZEBRA PIAS
Register now and access more than 125,000 products
The sealing washer consists of an A2 stainless steel metal back with vulcanised seal made of high-quality EPDM
Reduction of the assembly time using the drill bit tip by min. 50%:
- Drilling without centrepunching
- Thread moulding
- Securing
All in one operation
Suitable for component combinations tI / tII according to approval ETA-10/0184
- Steel/steel - for ∅ 6.0 mm
The zinc-plated part of this drilling screw may only be used where dampness is not to be expected. The A2 stainless steel covered head may be in the exposed area. For connection elements with a construction permit, the permit, and in particular Part 2 "Special regulations", must always be observed.
Ø 6 mm:
- General construction permit Z-14.1-4
- European Technical Approval ETA-10/0184
Datasheets(X)
CAD data (available after login)
Last viewed
1/2 inch socket TX IP
2-way blow-out gun With a control button for the infinitely variable adjustment of air flow
Quick-mount NPH clip
Cable tie KBL 1 made of polyamide with plastic tongue
Hexagon nut DIN 934, A2 stainless steel, plain
Stretch X S3 safety shoe
Tool case with all common tools 115 pieces
ELMO® speed screws Zinc-plated steel, blue, RW slot drive
Silicone fluid silicone spray
NP profile half cylinder In 6-pin system