Drilling screw, flat head with AW drive and minipoint pias^®

Especially suitable for thin sheet metal

Zinc-plated steel, blue passivated (A3K)

With metric thread

Drilling, thread forming, screwing in: all in one step

Therefore considerably reduced time and effort

Exact drilling diameter for any screw connection

• Minimisation of thread tolerance


• Always an optimum connection

Prevents mistakes in the installation

AW drive system:

• Enhanced torque transmission


• Longer service life


• Optimum centring


• Improved performance thanks to fatigue-free screwing in; the required contact pressure for transmission of the torques is considerably lower


• Largest possible contact surface of bit in screw drive


• Even force distribution prevents damage to the surface-protection coating and therefore ensures better resistance to corrosion

Galvanized drilling screws may only be used where dampness is not to be expected. For fasteners with a construction permit, the permit, and in particular Part 2 "Special regulations", must always be observed.