Direct to rust enamel smooth effect
Corrosion protection varnish
PENTOX BLACK RUSTPR.GLOS.PAINT.FL.FIN.4L
Register now and access more than 125,000 products
Features:
- Effective even on rusty metal surfaces. No need to remove rust; simply sand and remove poorly adhered particles.
- No need for primers or corrosion protection. Saves time and money, as a prior treatment does not need to be applied (see general recommendations). Indicated for outdoor and indoor use.
- Good coverage.
- Shiny rust-resistant enamel.
- High adhesion.
- An airtight seal is obtained to prevent the passage of moisture.
- Can be applied to iron, steel, galvanised surfaces, wood, new work, restorations or maintenance, enamel paints.
These instructions are merely recommendations based on our experience. We recommend performing tests for each new type of application or surface to be treated.
Datasheets(X)
Instructions for use
Shake before use until perfectly mixed. Apply to clean, dry surfaces.
Prepare the surface (see general recommendations). For proper protection, we recommend applying 120 dry microns of enamel. (2-3 coats).
Handle in ventilated areas.
Cleaning and thinning with solvent for direct to rust enamel art. no. 0828900600, according to the attached table.
General recommendations
Iron and steel
No need to remove rust; simply sand and remove poorly adhered particles and loose rust.
Apply 2-3 coats for proper protection.
Galvanised surfaces
Use primer beforehand for galvanised surfaces.
New wood.
Use wood sealant beforehand.
Gypsum, cement and derivatives
Remove saltpetre, moisture or any foreign products beforehand.
Paint
If the paint is in poor condition, remove it mechanically or chemically.
If the paintwork is in good condition, simply clean and degrease. If the finish is glossy or shiny, sand the surface to improve adhesion.
Do not apply on surfaces that are wet, heated or very hot.
Do not apply when the relative humidity is greater than 80 %.
Shelf life from production | 24 Month |
Last viewed
Sanding Plate D 150 mm For ETS 150-E twin random orbital disc sanders
Collated nails and gas cartridge NG CS-2/3 HFB
Replacement wheel For sanding disc dressing tools
Hexagonal bolt, with thread to head and fine thread DIN 961, steel, strength class 10.9, zinc-nickel-plated, transparent passivated (P3E)
Thin-walled heat-shrink hose Shrink rate 2:1 without internal adhesive
H121 Drawer slidebox Slender Metal Drawer
Anti-puncture wheel for Carro 3 - Motion Würth
Support clip type SRV
Suction hose, electrically conductive For ISS and TSS series
Ergopower Dual 25 W