Diamond disc turbo logo
Diamond cutting disc TURBO LOGO
CUTDISC-DIA-TURBOLOGO-GRANITE-125MM
Register now and access more than 125,000 products
- Precise and fast cutting thanks to its low thickness.
- The disc polishes while cutting thanks to the diamond additions located in the core of the disc (Würth logo).
- Continuous diamond belt for a higher cutting speed.
- Hardened, tensioned and balanced steel core to withstand the most demanding jobs.
- Cutting height of 9 mm to ensure long tool life.
Datasheets(X)
Precise cutting of all kinds of granites and silestones.
Cutting progress must be under the machine's own weight; do not exert any pressure.
Always install the disc so that the direction of rotation matches that of the machine.
Install the disc precisely, because eccentricity causes high wear and deformation of the diamond part.
Maintain exact blade pitch during cutting and avoid side-to-side oscillations or movements of the machine.
During work, it is essential to take breaks from cutting, allowing the blade to run idle for a few seconds to allow better cooling. This simple operation will extend the life of the disc.
Recommendations for use
D: 115 mm. - 12,000 rpm = 80m/s
D: 125 mm. - 11,000 rpm = 80m/s
D: 150 mm. - 10,000 rpm = 80m/s
D: 180 mm. - 8500 rpm = 80m/s
D: 230 mm. - 6600 rpm = 80m/s