Contact protective coating

Name: Contact protective coating
Brand: Würth
SKU: 089370

Contact spray SL
CNTCTPROTLAC-SL-200ML

Art.-no. 089370

EAN 4045727164686

All versions

Prices for customers after login

Contact protective coating

Art.-no. 089370

Prices for customers after login

Quantity

Exclusively for trade customers

Login/Register
Call customer service: +34928189825

Transparent spray protective lacquer

Prevents and rectifies soft shorts on coils and transformers

Prevents short-circuits in high and low-voltage areas

Provides a glossy and flexible protective film

Insulates and seals

Protects against water, diluted acids, bases and corrosion

Adheres to metals such as copper, brass, steel, chrome, aluminium

Notice

Contact SL must be completely dry before the electrical system is restarted. Do not work while energised. The product is highly flammable. Container is pressurised. Protect from sunlight and temperatures over 50°C. Turn the can upside down and spray after use. Before application, check product for material compatibility.

The usage instructions are recommendations based on the tests we have conducted and our experiences; test the product before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/usage conditions. Insofar as our free customer service provides technical information or acts as an advisory service, this service is provided under the exclusion of any liability, unless the advice or information given falls within the scope of our specified, contractually agreed scope of services or the consultant was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Product information

Würth Catalogue

Datasheets(X)

Safety data sheet

Certificates/ Documents

Application area

Seals all kinds of electrical cables. Insulates, seals, protects wiring and connectors from corrosion and contamination.

Instructions

Apply from a distance of approximately 25 cm at room temperature by spraying the corresponding, previously cleaned surface.

Contents	200 ml
Density	0.839 g/cm³
Density conditions	at 20°C

Suitable glove:

Product

Description

Chemical protective glove, Butyl

Description:

Permeation level: 1

Gas-tight and resistant to exhaust gases produced by combustion processes

Nitrile chemical protective glove With cotton velour finish inside

Description:

Permeation level: 1

Nitrile chemical protective glove Long, heavy-duty design

Description:

Permeation level: 2

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time

Permeation level

< 10 min

≥ 10 min

≥ 30 min

≥ 60 min

≥ 120 min

≥ 240 min

≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.