Combination locking claw
Combination locking claw
LOKCLW-(SML-CV-RAPID-CON)-DN70
Register now and access more than 125,000 products
- For single and two-screw connectors
- For interior pressure loads up to 10 bar for DN 50 – DN 100 (DN 125 – 150 5 bar, DN 200 3 bar)
- Suitable for all Rapid (except DN 250) connectors and all CV + CE two-screw connectors
- DN 250 for CV connectors only
For article numbers 0544007200 and 0544007250 the design features three claw sections
Datasheets(X)
- Rain and dirty water lines in backup areas
- Roof draining piping (HDE system)
- Lifting systems
- Loosely screw both claw halves onto pipe
- Make sure that claw halves do not sit on the clamp strap of the connector
- Tighten the screws diagonally to ensure even seating of the locking claw
- Observe tightening torques (check with torque wrench)
 | |
DN nominal width | DN 70 |
Material designation | S235JR |
Operating pressure | 10 bar |
DIN | 912 |
Diameter (D) | 144 mm |
Min./max. torque | 17-23 Nm |
Min. torque | 17 Nm |
Nominal diameter | 8 mm |
Nominal diameter x screw length | 8 x 30 mm |
Screw length | 30 mm |
Property class | 8.8 |
Thread type | Metric thread |
Length (L) | 72 mm |
Max. torque | 23 Nm |
EN standard | 10025 |
Last viewed
Triple square bit
Nozzle and needle kit ADVANCE W18
Manual caulking gun for cartridges Basic
AL 11 long plate pair
High Power battery
High Power battery
LED work light 4 high-powered LEDs
Hammer drill bit For large hammer drills with high impact energy
1/2 inch impact socket wrench insert hexagon, metric, short
Quick-change insert for insulated cable lugs