Combination locking claw
Combination locking claw
LOKCLW-(SML-CV-RAPID-CON)-DN250
Register now and access more than 125,000 products
- For single and two-screw connectors
- For interior pressure loads up to 10 bar for DN 50 – DN 100 (DN 125 – 150 5 bar, DN 200 3 bar)
- Suitable for all Rapid (except DN 250) connectors and all CV + CE two-screw connectors
- DN 250 for CV connectors only
For article numbers 0544007200 and 0544007250 the design features three claw sections
- Rain and dirty water lines in backup areas
- Roof draining piping (HDE system)
- Lifting systems
- Loosely screw both claw halves onto pipe
- Make sure that claw halves do not sit on the clamp strap of the connector
- Tighten the screws diagonally to ensure even seating of the locking claw
- Observe tightening torques (check with torque wrench)
 | |
DN nominal width | DN 250 |
Material designation | S235JR |
Operating pressure | 1.5 bar |
DIN | 912 |
Diameter (D) | 250 mm |
Min./max. torque | 50-65 Nm |
Min. torque | 50 Nm |
Nominal diameter | 12 mm |
Nominal diameter x screw length | 12 x 30 mm |
Screw length | 30 mm |
Property class | 8.8 |
Thread type | Metric thread |
Length (L) | 130 mm |
Max. torque | 65 Nm |
EN standard | 10025 |
Datasheets(X)
Last viewed
1/2" socket wrench insert For TX screws, short
Paint protection film
Fibreglass rod For CPS cable feed device
Driver Classic protective glove
System insert 4.4.1, bits
Foam interface for sanding plate for W-200 grinding machine and sander
Wall chaser MSF 180N
Covering plug, type 4 Pine tree shape, interrupted
Wallpaper smoothing brush With a mixture of China and polyester bristles
Flat washers Standard range ISO 7089 polyamide 6.6 natural
