Combination filling appliance
Combination filling appliance
FILR-LUB-COMBI-F.GREASE-25KG
Register now and access more than 125,000 products
Suitable for filling:
- Lube-Shuttle system cartridges in conjunction with a refill adapter
- Hand-lever grease guns
- Single-handed guns
- Lubricating units with filling nipple in accordance with DIN 1283
Commercially available greases up to NLGI Class 2 can be used. We expressly exclude any other use.
Lube-Shuttle® is a registered trademark of MATO GmbH & Co KG.
Datasheets(X)
The combination filling appliance is suitable for filling Lube-Shuttle® system cartridges in conjunction with a refill adapter, hand-lever guns, single-handed guns and lubricating units that are equipped with a filling nipple in accordance with DIN 1283, with commercially available greases up to NLGI Class 2.
- Open the grease container and press the grease sequence piston firmly onto the grease.
- Place the centring cover onto the grease container.
- Loosen all 3 thumb screws and slide the centring slide inwards (towards the centre).
- Using the bolts, push the retaining claws outwards as far as they will go.
- Then place the centring cap onto the grease container so that the retaining claws are outside
- and the centring slides are inside the grease container.
- Push the centring slides outwards using the thumb screw as far as they will go. (Lid centres
- itself automatically on the grease container)
- Hold the thumb screw pressing outwards and slide the retaining claw inwards as far as it will go
- using the bolt. Tighten the thumb screw securely.
- Secure the remaining 2 thumb screws and bolts as described above.
- CAUTION!! Check that the centring cap is firmly seated on the grease container.
- The pump can now be pushed through the clamp and secured by means of clamping
- screws.
- The combination filling device is now ready for use.
- Press the lubrication device with the filling nipple onto the filling nozzle of the filling device. The filling nozzle has
- a lock valve.
- The grease automatically pushes back the sealing sleeve in the grease container during the filling process. The
- piston rod of the grease container must be inserted fully before filling. When increased
- resistance is felt at the hand lever of the filling device, the filling process is finished.
Material | Steel |
Material of piston | Brass |
Material of gasket | Nitrile butadiene rubber (NBR) |
Suitable for inner diameter of grease bucket | 300-335 mm |
Lid diameter | 365 mm |
Height | 535 mm |
Product weight (per item) | 5380.000 g |
Included in delivery | Scope of delivery: pump unit with filling nozzle for filling nipples according to DIN 1283, centring cover, grease sequence piston |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Threaded pin For furniture castors
Micro cartridge 425 g For soldering iron
Aluminium airline lashing rail with round cord
Cutting knife, curved
Hinge pin For shutter hinges
Brake line nipple, type L
Quick-action chuck Metal sleeve
Wood patches
Circular saw blade, wood For cordless hand-held circular saw HKS 10-A/12-A
Polishing Paste For sisal/cloth rings, polishing rings