Comb nail / anchor nail
Ridge nail/anchor nail steel zinc plated
RIDGNL-(A3K)-4X100MM
Register now and access more than 125,000 products
- The tapered section below the nail head ensures that the nail fills the hole in the wood connector ensuring an exact transfer of force
Nails in accordance with DIN EN 14592 and A1 (Eurocode 5)
Datasheets(X)
Angle brackets, joist hangers, cross connectors, steel plates and moulded steel plate parts, rafter-to-purlin connectors, rafter foot fittings, perforated plates, flat steel anchors, diagonal bracing etc.
Diameter | 4 mm |
Length | 100 mm |
Head diameter | 8 mm |
Material | Steel |
Surface | Zinc plated |
Thread length | 75 mm |
Last viewed
Wire end ferrule with plastic sleeve according to DIN 46228 Part 4
Hammer-resistant lightweight core bit
GEFU® thread-rolling screw With Taptite 2000® thread, cylinder head and hexalobular drive
1" slider bar With pin detent
3/4-inch impact socket wrench insert hexagon, metric, short
Superglue set, 3 pcs
MFD-S combi stone drill bit assortment 10 pieces
1/4-inch, 3/8-inch and 1/2-inch sockets Assortment of 77 pieces
Adjusting ring DIN 705, shape A and DIN 553 set screw, zinc-plated steel, blue passivated
Screw fitting