Comb nail / anchor nail
Ridge nail/anchor nail steel zinc plated
RIDGNL-(A3K)-4X100MM
Register now and access more than 125,000 products
- The tapered section below the nail head ensures that the nail fills the hole in the wood connector ensuring an exact transfer of force
Nails in accordance with DIN EN 14592 and A1 (Eurocode 5)
Datasheets(X)
Angle brackets, joist hangers, cross connectors, steel plates and moulded steel plate parts, rafter-to-purlin connectors, rafter foot fittings, perforated plates, flat steel anchors, diagonal bracing etc.
Diameter | 4 mm |
Length | 100 mm |
Head diameter | 8 mm |
Material | Steel |
Surface | Zinc plated |
Thread length | 75 mm |
Last viewed
Cable clamp In accordance with DIN 72571
Soft Interface foam
Screwdriver handle with hex bolster
Double open-end wrench assortment 8 pieces
Electronic polishing machine WPS 180-E
Timing tool set suitable for VW Group 1.8-2.0 TFSI with timing chain 10 pieces
Standard cable tie with plastic latch
LED built-in light For recessed installation
Staples for hand-held stapler and hammer tacker
TX double box-end wrench