Coating RECUFIBER
Waterproof surface coating RECUFIBER
SRFCOAT-WTRPROF-RECUFIBER-RED-5KG
Register now and access more than 125,000 products
Properties
- Waterproof and breathable.
- Excellent adhesion to the substrate.
- Absorbs expansion and movement.
- The colour range is very stable in sunlight.
Do not apply in adverse weather conditions such as relative humidity above 95 % and temperatures below + 5°C, or when rain is imminent.
Wait at least 4 to 6 hours between coats for painting. Where the product is applied more thickly, such as on a chimney edge, drying can take significantly longer. In these cases, it is advisable to leave a day between coats to dry thoroughly.
This data only contains recommendations based on our experience. Testing prior to use is recommended. For more information, see the product data sheet.
Datasheets(X)
Protection against rainwater, unpressurised moisture and leaks both horizontally and vertically.
Especially suitable for horizontal surfaces when the geometry or planimetry of the surface is complicated (corners, irregular edges etc.) or you are working around previously installed fixtures (machinery, air conditioning, refrigeration equipment etc.).
On vertical surfaces, it is used in joints, cracks, fissures, as a one- or two-layer filler material etc.
Waterproofing in conflict areas such as: chimney edges, tiles, mortared ridges etc.
Supplied ready to use. Can be diluted with a maximum of 10 % water.
The substrates must be clean and dry, free from other waterproofing agents, grease, moss, dust etc. We recommend using Recuprimer primer art. no. 0893199800 (especially poorly absorbent substrates without pores).
Applied with a flat brush, trowel or spatula.
Apply without over-spreading.
Ideally, apply two cross coats.
Consumption
Horizontal: 0.700 kg-1 kg m2 (depending on the porosity of the surface).
Vertical: 0.350 kg-0.500 kg/m2 (depending on the porosity of the surface).
Chemical basis | Polyvinyl acetate dispersion |
Colour | Red |
Min. processing temperature | 5 °C |
Max. processing temperature | 40 °C |
Contents | 3.67 l |
Shelf life from production | 12 Month |
Technical data | |
Composition | Saturated polyesters in dispersion |
Density | 1.3 g/cm3 |
Appearance | Fibrous paste |
Viscosity at 20°C | 8000 cP |
Type of thinner | Water |
Elongation at break | ± 250 % |
Solid content | 58 % |
Application temperature | Between + 5°C and 40°C |
Dry to touch | Approx. 2 hrs. |
Completely dry | Approx. 4 hrs. |
Paintable | Between 6 and 8 hrs. |
Ready to bear a load | 24 hrs. approx. |
VOC content 2004/42 Cat II A (i) 140 g/L. Max. VOCs: 3 g/L |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!